Firmware v3.02.0 adds three new vendor commands:
- 0xB7 SIGNAL_MONITOR: fast 8-byte combined signal read
- 0xB8 TUNE_MONITOR: tune + dwell + read in one round-trip
- 0xB9 MULTI_REG_READ: batch read up to 64 indirect registers
New tools/skywalker.py provides five modes that use the BCM4500's
AGC registers as a crude power detector across 950-2150 MHz IF,
even without demodulator lock:
- spectrum: sweep analyzer with ASCII/waterfall/matplotlib display
- scan: automated transponder scanner (sweep + peak detect + blind scan)
- monitor: real-time signal strength for dish alignment
- lband: direct input analyzer with L-band allocation annotations
- track: carrier/beacon tracker with CSV/JSON logging and drift detection
Extracts shared SkyWalker1 class and constants into skywalker_lib.py;
tune.py now imports from the shared library.
Removed I2CS bmSTOP "bus reset" from bcm4500_boot() and debug modes.
Sending STOP with no active transaction puts the FX2 I2C controller
into an inconsistent state where subsequent START+ACK detection fails.
Root cause identified through incremental debug modes (wValue 0x80-0x85)
on live hardware: mode 0x82 (with bmSTOP) fails, mode 0x85 (identical
but without bmSTOP) succeeds. Raw I2C reads confirm BCM4500 is alive
the entire time -- only the controller state is corrupted.
BCM4500 now boots successfully in ~90ms. Three I2C devices found on
bus: 0x08 (BCM4500), 0x10 (tuner/LNB), 0x51 (EEPROM).
Also in this commit:
- Timeout-protected I2C functions replacing fx2lib bare while loops
- I2C bus scan and debug mode infrastructure
- Kernel driver blacklist for dvb_usb_gp8psk
- Test tools for incremental boot debugging
- Technical findings documented in docs/boot-debug-findings.md
Correct BCM4500 I2C address from 0x10 (8-bit wire) to 0x08 (7-bit)
since fx2lib shifts internally. Add i2c_combined_read() with repeated
START for proper BCM4500 register access. Add I2C bus scan (0xB4),
raw read (0xB5), and indirect protocol diagnostic (0xB6) commands.
Single-transaction indirect reads/writes for BCM4500 register protocol.
Verified on hardware: BCM4500 ACKs at 0x08, BOOT_8PSK returns config
0x03. Register reads still return zeros — BCM4500 needs DSP firmware
loaded via LOAD_BCM4500 (0x88) before registers become functional.
Custom firmware (SDCC + fx2lib) implements all stock vendor commands
(0x80-0x94) plus new commands for spectrum sweep (0xB0), raw BCM4500
register access (0xB1/0xB2), and blind scan (0xB3). Compiles to 6.3KB
of code with healthy RAM margins.
RAM loader (fw_load.py) uses the FX2 0xA0 vendor request to load
firmware into RAM without touching EEPROM -- power cycle restores
factory firmware. Supports Intel HEX and raw binary formats.
